2-4 dages levering

Alle ordre sendes med DAO.

Vegansk & ikke testet på dyr

Vi tænker på dig & miljøet.

Vandfast

Alle vores produkter er vandfaste.

Allergivenlig

Vores produkter er skånsomme & allergivenlige.

chevron_left chevron_right

Here's how you do it

How to use TK bond & seal

If you use this with our regular striplashes or other striplashes, it is important that you cut the lashes so that the individual lash is divided into 4-5 bouquets. This makes them easier to apply and makes them last longer.

Step 1: Use the lash applicator (ordinary tweezers can also be used for the purpose) and grasp the lashes carefully. Get a bit of our "bond" on the lash line. You can be content with using very limited product.

Step 2: Lift your eyelid slightly with one hand so you can better see your natural lash line. Always start from the outside and work your way inward. Then, with your other hand, apply the lashes, under your natural lashes. If the lashes are positioned incorrectly, you can move them around until they sit as desired.

Step 3: Then let our "bond" dry for 20-30 seconds when you have attached all the lashes. By using the lash applicator, you can now gently clamp your natural lashes together with your artificial lashes. Repeat the same steps on the other eye.

Step 4: When you have applied all the lashes as desired, our "seal" is used to bind your natural lashes and the artificial lashes together. Gently brush through the lashes as you would apply mascara. Again: use limited product only. This step can be repeated daily to make the lashes last longer.

Step 5: If you want to remove the lashes, you can easily use an oil-based make-up remover. The lashes are then cleaned and reused.

NOTE: If you feel that the lashes do not stick properly, you can use more of our "bond", or try applying a bit of bond to your natural lashes.

NOTE: Avoid getting water on the lashes for the next 12 hours. Avoid oil-based products on the lashes, unless they need to be removed.

How to use TK clear lash glue

Our eyelash glue can be used for all types of striplashes and other lashes. The lash glue is waterproof,

Step 1: Be sure to remove any residue from previous make-up or eyelash glue, and wait until your lashes are dry. Use the easy application brush to apply lash glue to the lash line of your artificial lashes.

Step 2: Wait 15-20 seconds for the eyelash glue to get a firmer consistency. Then, using the lash applicator or tweezers, apply the artificial lashes on top of your natural eyelashes.

Step 3: With the lash applicator or tweezers, clamp your natural lashes together with your artificial lashes. Wait 30 seconds for the eyelash glue to dry. Then use an eyelash curler to curl the lashes slightly, for a more natural result.

NOTE: The lash glue dries and becomes transparent/transparent. It lasts up to 24 hours.